HTA25PM Series

Multi-Turn Analog Rotary Shaft Encoders

Hall encoder in Ø25 mm metal housing (up to IP65S+)

Absolute encoder:*

• *Maximum shaft rotation in powered-off state without losing reference is ±179º
• Measuring range up to 72000° (200 shaft revolutions)
• Programmable are the sense of rotation (CW/CCW) and the effective electrical angle [°]
• Programmable up to 10,000 times
• Factory programming: effective electrical angle of rotation 3600° (10 turns), sense rotation CW
• Supply voltage: 9 to 30 VDC, 15 to 30 VDC
• Output signal: 4 to 20 mA, 0 to 5 V, 0 to 10 V
• 12 bit resolution (per turn)

HTA25PM encoder - robust, ball bearings, sealed

The HTA25PM multi-turn encoder is a robust encoder with magnetic sensor technology. This is due to the solid aluminum housing, the high IP protection class and a double ball-bearing stainless steel shaft that withstands high axle loads and allows high actuation speeds. The signal processing is digital and based on magnetic recording of measured values. The gradient-based evaluation ensures high interference immunity, e.g. B. against temperature fluctuations and EMC influences achieved. This technology leaves the disadvantages of conventional Hall sensors far behind. HTA25PM rotary encoders are designed for maximum service life and even surpass the robust optical data acquisition. The number of defects or failures in rotary encoders with this technological design is practically zero, even after decades of use.

Customer specific modifications such as shaft geometries, signal output functions, special cable lengths or individually assembled electrical connection cables are available.